When configuring SMTP or syslog for alerting the easiest way to configure is in the GUI, simply because everything you need to configure is right there in plain sight.
For this example, we will assume the syslog servers and SMTP relay host and sender domain have been specified. If not, these can be set from the GUI under Settings > System > Syslog servers and Settings > System > Alert Routing.
But to test if it all works is a different story: there’s no test button!
So we need to log on to the CLI. Use your favorite SSH client and log on the the array.
Syslog
First you can view if the syslog was configured according to your liking by entering the command:
purelog list
You should now see the configured syslog servers and the ports that are used.
To test if syslogging works enter the command:
purelog test
SMTP
For emails the command to view the settings is:
purealert watcher list
You should now see the email addresses that will be used whenever the array needs to send an email. To test this you need to use the following command:
purealert watcher test address@domain.com
If all goes well you will then receive an email similar to:
Hello,
This is a test message from your Pure Storage Array.
Controller Serial: PCTFL1953173B
-Pure Storage Array PUREARRAY-027-ct0
0 Comments.