A quick heads-up this time about building your own lab environment
Sometimes you just want to run a VNX, Avamar, PowerPath, Data Domain or Isilon as a virtual machine to see how things work, or to write work instructions. And EMC offers a lot of these virtual appliances for free!
Take a look at these:
When using enhanced device aliases, make sure you enable this on the new switch as well:
device-alias mode enhanced
device-alias commit
You can verify if this is enabled on an existing switch by this command:
sh run | grep “device-alias mode”
In my smart zoning post from last February I already presented the way to get started with Cisco smart zoning. I initially planned to give a more detailed calculation on how much time you can save if you were using smart zoning compared to SIST zoning.
I was talking to an EMC SAN instructor (Richard Butler) this week and after I did a little white-boarding and used my hands to picture how massive a traditional SIST zone environment would be, we agreed smart zoning is the way to go.
Previously I wrote about setting the NTP, time and timezone settings in a Cisco switch and now it’s time for the same in a Brocade switch.
It’s in fact not that hard to do. Log in to the CLI and use the following commands:
tsclockserver 1.2.3.4
or
tsclockserver ntp.domain.ext (make sure the DNS is set up properly first)
This will set the NTP server address in this switch to ip address 1.2.3.4. Set this only on the principal switch, as this switch will propagate the time to the other switches in the fabric.
To set the timezone use the following command:
tstimezone –interactive
(please note that there’s a double “-” before “interactive”)
This will ask for the region and country the switch is located in.
Choose 8 for Europe and 34 for the Netherlands and after verifying the setting, choose 1 (yes) to set the TZ.
Use the “date” command to verify the current time and date and TZ region:
Wed May 13 01:08:32 CEST 2015
This makes life a lot easier when troubleshooting!
If you have multiple datacenters or a multi tenant fibre channel environment and you’re using Cisco FC switches, it’s a best practice to use VSANs to separate the configurations of each location / tenant. To allow storage arrays and / or hosts in different VSANs to communicate with each other Inter VSAN Routing needs to be used.
If you need to have 2 EMC VNX storage arrays “talk” to each other for MirrorView for example over 2 or more datacenters (for data replication purposes that is) or hosts in one DC talk to storage in another DC, using transit VSANs (and therefore IVR) will keep your VSANs with equipment indoors and the slightly more vulnerable VSAN outdoors. If some farmer with his tractor rips your single mode fiber, only the outdoor VSAN will be fractured and the indoor VSANs remain unharmed. And of course communication between the remote sites is interrupted, but the indoor VSANs / fabrics remain unchanged.
EMC Elect 2013, 2014, 2015, 2016 and
Dell EMC Elect 2017
Follow me on social media